The Miner Model is designed for high volume applications with adjustable height frame and a plastic skirt which directs all the waste material to the rear.

Gold Genie manufactures three different quality spiral gold wheels.

All three are designed to recirculate water with a 12 volt pump which is provided and have the following features.

The Gold Genie spiral recovery machines have a quality 18 inch blue spiral pan for easy observation of both gold and black sand.

The pan is injection molded from polypropylene plastic.

The injection molding under heat and pressure assures an exact copy of the mold with sharp definition of the ridges in the pan which are critical for gold recovery.

The deep cut spirals with sharp edges allows the system to work wet or dry.

The controls for both the volume of water from the spray bar and the critical angle of the pan are designed to be easily and accurately adjusted.

The heavy duty 12 volt dc motor has two switchable speeds.

The low speed is about 15 rpms and the high speed is about 22 rpms.

The switch can be set for high speed, low speed, or off.

A separate switch is provided for the 12 volt dc water pump, so the units can operate with or without water.

The motor and pump have a total current draw of less than 4 amps.

The gold and other values are collected on the back side of the spiral pan in a high capacity 10 inch gold pan.

The fitting in the center of the 18 inch spiral pan, that the gold travels through, is made of high quality stainless steel so that the machines can also be used for amalgamation.

The frames are all made from anodized steel for years of rugged service.

5 YEAR Limited WARRANTY